Risk Racing The Ripper Universal Automated Goggles Roll-Off System
The Goggle Roll-Off System Revolutionized
The Ripper is a revolutionary system for the Roll-Off Goggle. With the press of the wireless handlebar button, The Ripper rapidly pulls the cord on most roll-off systems to clear the riders vision in less than a second.
The Ripper
The wireless main unit replaces the need to take your hand off the handlebar to reach up and pull the cord on the roll-off system. Not only is this safer, but faster, and means you're free to clear your vision whenever you NEED to!
Wireless Handlebar Remote
The remote sits conveniently next to your grip, allowing easy access to press the button.
Rapid Visibility
With a tap of the button, the arm pulls the cord in a rapid-fire motion, clearing vision in less than 1 second*
Keep Your Hand on the Bar
With the Ripper you no longer need to take your hand off the the handlebar to clear your vision!
Quick Setup
It takes minutes to setup the Ripper and operation is as easy as pushing a button.
- Mount to strap - Feed the strap through the strap mounts, then slide the Ripper forward until it touches the back of the roll-off canister.
- Hook Pull Arm - Pull out the pull-cord and hook the Ripper pull arm over the cord.
- Set Mode - Turn on the unit then quick press the sync button to change between Auto-Burst or Momentary/Continuous mode.
- Mount Remote - Place wireless remote button in desired location, then screw back mount and tighten down.
Manual Override
The pull cord is still operational even when The Ripper is attached.
Sync Multiple Remotes
Sync the Ripper to multiple Wireless Remotes for multiple bike setups.
Extra buttons available
Universal Mount
Universal goggle strap mount works with your favorite goggle roll-off system*.
Auto-Burst
Press Remote button to activate the Ripper for approx. 1.5 seconds. Use this mode to clear vision automatically with a tap of the button.
Momentary / Continuous
Press & HOLD Remote button to activate the Ripper for desired time (up to 5 seconds). Use this mode to have more control of roll usage.
Rechargeable
The Ripper will typically last up to 10 rolls before needing to be recharged via the micro-USB port on the main unit. Battery level is indicated by the 3 LEDs
Lightweight
At only 4.1oz (116g) it's lighter than the typical action camera setup and almost half the weight once you include action camera mounting hardware.
Features
- Clear goggles in as little as 1 second
- No more taking hands off handlebar to clear roll-off
- Use almost any roll-off goggle*
- Manual override incase of mechanical failure or damage
- Quick set up
- Auto-Burst Mode or Momentary/Continuous Mode
- Sync multiple Rippers to one remote for quick change in race situation
- Micro-USB rechargeable
- Battery life lasts up to 10 rolls
- Weather Proof
- Lightweight at only 4.1oz (116g)
Specification
- The Ripper
- Handlebar Mount Wireless Remote
- RF wireless transmission
- Micro Motor
- Strap Mount accommodates straps up to height of 2 inches (50mm)
- Modes: Auto-Burst Mode, Momentary/Continuous Mode
- Ripper Main Unit Battery: Lithium-ion Rechargeable Battery Pack (Integrated), 3 LEDs = 100%, 2 LEDs = 66%, 1 LED = 33%, Blinking LED <10%, Battery Life: Up to 10 full rolls
- Remote Battery: CR2032 Lithium Battery (replaceable)
Dimensions
The Ripper
- Size: 4.4” x 1.5” x 2.75” (11.2cm x 3.8cm x 7cm)
- Main Unit Weight: 4.1oz (116g)
Handlebar Remote
- Size: 1.5” x 1.7” x 1.9” (3.9cm x 4.4cm x 4.7cm)
- Weight: 0.6oz (17g)
Model# 00395
1 year warranty
Includes
- The Ripper
- Wireless Handlebar Remote
- Instruction Sheet
Note
California Prop. 65 WARNING:
This product can expose you to Bisphenol A, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.